Friday, October 18, 2019

Stabilizer Rebuild

The rod end bearings were getting sloppy, I decide to do the work myself.  It made good sense as we were replacing the washer dryer and that made it easier to cut a nice big hole for access under where the washer dryer would normally be. Since we were in there anyway and we were at the hours recommended we change the cylinders, trunnion and rod end bearings.

 Access??? Hmmm not really possible to work on this actuator from the provided shower access.

 So, remove your Washer/Dryer and cut a big opening.

Thanks to Daryl at TRAC for helping walk me through this via WhatsApp.

No comments:

Post a Comment